|
Specimen Holders
Different configurations of specimen holders add
to the versatility of the TABER Abraser
(Abrader), and permits testing most any
material. All holders are interchangeable, and
have been designed to lock in place yet still be
easily removed from the abraser (abrader)
A common feature to most specimen tables is the
clamp plate and nut. Mounted on top of your
specimen, these help keep flexible materials
flat and rigid materials secure. The rubber pad
(S-19) ensures specimen materials do not slip
during testing.
E100-125; Specimen Holder [part# 120990]
Test all rigid, flat specimens of any material (standard
specimen holder included with all abrasers).
E100-101; Hold Down Ring (4 17/64" ID) [part# 125795]
Used for flexible materials up to 1/16" thick [use with
E100-125].
E100-102; Hold Down Ring (4 21/64" ID) [part# 125796]
Used for flexible materials up to 1/16" thick [use with
E100-125].
E100-10; Transparent Plastic [part# 121205]
Used for viewing textile specimens against a light source to
determine wear characteristics without having to remove the
specimen from the holder. (Can be used with E100-101 or
E100-102).
E140-14; Ring Clamp Holder [part# 121155]
Eight (8) screws spaced evenly on the clamp plate allow you
to test slightly warped specimens (dry or wet). Furnished
with (S) or without (NS) center screw.
E140-15; Textile (Tensioning Type) [part# 121148]
Used for flexible materials. Incorporates a raised wear
track to provide extra tensioning to the material when the
hold down ring is drawn down over the edge of the holder and
clamp plate is mounted. Requires 5 ¼" circle of test
material.
E140-18; Textile (Rimmed) [part# 121208]
Used for flexible materials. This holder provides an initial
stretch to woven fabrics, thereby minimizing their tendency
to wrinkle if they are tested moist.
E140-19; Drive Pin Type [part# 121207]
Used for rigid, square specimens without the need for a
center hole. Specimens are attached to this holder with S-37
or S-37-1 mounting sheets.
E140-21; Threaded Ring (NEMA) [part# 121206]
Used for slightly warped specimens, this holder incorporates
a clamp plate and flanged clamp ring. The clamp ring is
threaded to the body of the holder, which securely holds the
outer edges of a specimen up to 5 3/8" diameter.
E140-75; Rimmed Specimen Holder [part# 125604]
Used for wet testing materials. A 3/8" raised rim retains
liquids, allowing you to determine the effect of absorbed
and or surface moisture on abrasion resistance.
E-3945; Multiple Specimen [part# 121241]
Divided into eight (8) sections, this holder permits
simultaneous testing of lightweight, flexible specimens.
Used primarily for nylon hosiery and light fabrics.
Specimen Holder - Silicon Rubber Wet Test [part#
121241-1]
Specially designed for testing silicon rubber products
(including breast implants). Abraser modification required.
S-19 Replacement Pads [part# 121016]
Rubber pads for specimen holders (4 ¼" OD)
S-21 Extension Nut [part# 121224]
Use this center nut to test materials ¼" - ½" thick
(requires a 3/8" center hole).
Arm Height Extension Kit
[part# 132160]
This kit changes the position of the abraser arms to permit
the evaluation of samples up to 40mm. A set of shims permits
the user to maintain proper position of the arms relative to
the test specimen. [Requires instrument to be returned]
Top
|
